The best solution for joining and tensioning wire for farming and livestock use.
Up to 70% faster than traditional systems
High durability and reusable
Wire diameter range
1,8 – 3,2 mm(0.07 – 0.13 inches)
400 Kg (880 lb)
Made with high-quality materials to ensure a long life.
All components are metallic.
Robust, reliable and long-lasting.
High mechanical strength and corrosion resistant.
FUNCTIONALITY AND INSTALLATION
The MAXTENSOR® MX2 joiner and tensioner is specially designed for joining and tensioning wires on vine trellises and wire meshes on farm and livestock fencing. It also enables damaged sections of trained vine wires, fencing and enclosures, among others, to be repaired. There is a small separation between wires, facilitating insertion and tensioning, while enabling comfortable placement of the tool, in addition to protecting the wires against premature corrosion.
The internal mechanism of the MAXTENSOR® MX2 tensioner connector enables free passage of wire in the direction of the arrow, and it is blocked immediately when it is pulled in the opposite direction.
It is designed to make it easy to insert the wire.
TENSIONING OF WIRE
Easy to install: up to 70% faster than traditional joining systems.
They have two entry holes opposite each other through which the wires are fed.
Once connected, the system may be tightened more firmly by pulling one of the wires using the MAXTENSOR® MX-AC and MC-FV tensioning tools.
Leave a minimum length of 10 cm from the free end of the wire to the outlet hole of the tensioner (see image).
TIPS FOR USE
When planning the installation with Maxtensor® connectors and tensioners, you must take into account the following tips for use.
The range of connectors and wire tensioners are usable with many of the wires for agricultural use on trellises, fences, or support wires. Given the variety of types of wire existing in the market, it is recommended to consult the technical department of Maxtensor Internacional S.L. on which would be the most suitable product depending on the application and the type of wire used.
Do not use the product outside the recommended range of diameters.
Do not exceed the load limit of any product.
The indicated load limit is a static load value, and depends on the type of wire and diameter used. If you think that the product will be subject to high loads, use wire diameters close to the maximum value of the range indicated on the product. In case of doubt, it is recommended to consult the technical department of Maxtensor Internacional S.L. on which would be the most suitable product depending on the application and the type of wire used.
It should be taken into account that the dynamic loads produced by the wind, impacts, vibrations, can significantly increase the service loads on the wire affecting the operation of the product.
It should be taken into account that dirt, chemicals and insects, among others inside the product, can jeopardize the proper functioning of the device.
Leave a minimum length of 10 cm from the free end of the wire to the outlet hole of the product.
Secure free ends of excess wire.
Check the installation status regularly.
PACKAGING AND WRAPPING
Plastic bag in a reinforced cardboard box.
Colour-coded label for reference and ease of identification.
Packaging size: 30 x 25 x 7 cm
Packaging weight: 8 kg
Contents of the box:
300 units MAXTENSOR® MX1